Avanti 261YGW/YGB - Manual (Page 4)

INSTALLATION
• Place your appliance on a floor strong enough to support it when fully
loaded.
• This appliance is designed for free standing only and should not be
recessed or built-in.
• Let air circulate freely around appliance. Keep rear 4 inches away from
wall and at least 3 inches space on sides.
• The location you choose should be away from beat sources like stove,
heater or radiator.
• .-\void installing your appliance in humid places (like next to sinks).
SETTING THE TEMPERATURE CONTROL
The temperature control dial has settings from the warmest(‘‘Min”) to the
coldest(‘‘Max") counterclockwise,plus “OFF”.
Initially set the dial to the “NORMAL'’position. After using the refrigerator
for a full day, adjust the dial to the setting that is best suited to your needs.
Turning the control to the "OFF”stops the cooling cycle. You must allow
at least 3 minutes before starting it again.
CLEANING AND MALNTENANCE
Unplug the refrigerator and remove food,shelves and tray. Wash inside with
a solution of warm water and baking soda. Then rinse and dry. Do not use
soaps,detergents or spray cleaners as they may cause odors inside compartment.
Wadt ice cube tray, Selves and drip tray in mild detergent solution and dry-
with a soft cloth.
To help prevent odors, leave an open box of baking soda inside the
refrigerator, on the shelf.
Wipe outside of refrigerator with a soft cloth dampened with soapy water.
Use only mild, soapy water to clean the door gasket.
VACATION AND MOVING CARE
VACATION
Remove all the food if you are going for a month or more. Unplug the
refrigerator and clean it. Rinse well and dry. Keep doors open far enough
for air to get in. This will keep odor and mold from building up.
- 2 -