Avanti DG240 - Manual (Page 16)

CARE & MAINTENANCE
BURNERS AND GRIDS
These parts can be removed and
cleaned \vith appropriate products.
/ After cleaning, the burners and their
flame distributors must be well dried
and correctly replaced.
It is very important to check that the
burner flame distributor and the cap
has been correctly positioned - failure
to do so can cause serious problems.
■/ In appliances with electric ignition
keep the electrode dean so that the
sparks always strike.
^ Note: To avoid damage to the elec­
tric ignition do not use it when the
burners are not in place.
CORRECT REPLACEMENT
OF THE BURNERS
It is very important to check that the
burner flame spreader “F" and the cap
“C" have been correctly positioned (see
figs. 20 and 21).
Failure to do so can cause serious
problems.
in appliances with electric ignition, check
that the electrode “S” (fig. 20) is always
clean to ensure trouble-free sparking.
The ignition plug must be very
carefully cleaned.
OVEN SHELF INSTALLATION
AND REMOVAL
The oven shelves are provided with a secu­
rity block to prevent accidental extraction.
They must be inserted operating as per
figure 22.
To pull them out remove shelf in the
inverse order.
Keep attention to insert the shelves cor­
rectly (see side figure).
OVEN DOOR
The internal glass of the oven door can be
easily removed for cleaning by unscrew­
ing the two lateral fixing screws (fig. 23).
REMOVABLE STORAGE
DRAWER
The drawer (fig. 24) comes out like a
normal drawer.
To remove the drawer open and lift it.
Figure 20 Figure 21
Figure 22
Figure 23 Figure 24
Do riot store flammable material in
the oven or m the bottom drawer.
76