Avanti FF8Y User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING YOUR REFRIGERATOR
MIN
When ambient Temp, is below 15’C or 59 *F
MED ^
When ambient Temp, is between 15-25*C or 59-77‘F
MAX
When ambient Temp. Is above 25*C or 77*F
WINTER
if ambient temperature is below 10’C or 50’F
* Setting the Temperature Control
• To control the internal temperature, adjust the control dial according to the ambient temperature or
purpose of use.
• The first time you turn the unit on, set the temperature control to “MAX”.
• The range of the temperature control is from position “MIN” the warmest to “WINTER” the coldest. After
24 to 48 hours, adjust the temperature control to the setting that best suits your needs. The setting of
“MED” should be correct for home or office refrigerator use.
‘‘Winter” Position: Select the ‘WINTER" Position when the temperature in the area where the
appliance is located is colder than 10°C or 50°F. This enables the freezer section to operate properly.
NOTE:
• if the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before restarting the unit.
If you attempt to restart before this time delay, the refrigerator will not start.
* Use of the Ice Cube Trays
• For your ice requirements, fill approximately 3/4 of the tray after washing it.
• To release the ice cubes, hold the tray upside down and twist slightly at both ends until the pieces of
ice fail.
CARE AND MAINTENANCE
Defrosting
You will never have to defrost your refrigerator as it is designed to do it automatically. The defrosted
water drains into the evaporator tray located in the backside. You should clean the tray at regular
intervals. To get to the evaporator tray, remove the screws holding the plastic back cover located in the
rear (bottom).