Dual XD1222 - Manual (Page 5)

5
General Operation
Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push left
side to secure.
Remove trim ring and install supplied #1 x 7/32” Phillips head
screw through left side of mounting frame into faceplate.
Press PWR to turn the unit on. Inserting a CD will turn the
unit on automatically. Press PWR to turn the unit off.
Press MODE to select between AM/FM, CD or auxiliary input.
Modes of operation are indicated in the display.
Press and hold LOUD for 2 seconds to activate and deactivate
the loud feature. Activating this feature will enhance the
bass and treble frequencies when listening to music at low
volumes.
Insert a 3.5mm connector in the front panel AUX port.
Connect the other end of the 3.5mm connector to the
headphone output of an audio device, MP3 player, etc. Press
MODE to select AUX mode.
Adjust volume using the rotary encoder (00-46).
Press DISP to display the clock. The radio frequency (tuner
mode) and CD track/elapsed time (CD player mode) will be
shown by default.
Press DISP to display the clock, then release. Press and
hold DISP for 2 seconds, the clock will begin to flash. Press
TRACK
nn to adjust the hours and TRACK ll to adjust
the minutes. Clock settings will be saved after 5 seconds.
The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10:00). In European frequency spacing
mode, the clock will display 24-hour time (22:00).
Press and hold for more than 2 seconds to RESET the unit
upon initial installation. The RESET button is located behind
the faceplate.
Faceplate Removal
Semi-permanent Faceplate
Installation
Power On/Off
Mode
Loud
Auxiliary Input
Volume
Display
Set the Clock
12/24-hour Clock
Reset
XD1222 OPERATION