Avanti 1043 YW - Manual (Page 5)

ELECTRICAL CONNECTION SETTING THE CONTROLS
RECOMMENDED
GROUNDING METHODS
This appliance should be properly grounded
for your safety.
The power cord of this appliance is
equipped with a three-prong plug which
mates with standard three prong wall outlet
to minimize the possibility of electric shock
hazard from this appliance.
* Do not, under any circumstances, cut or
remove the third ground prong from power
cord supplied with this appliance.
* Use of extension cords are not
recommended.
The location you choose should be away
from heat sources like stove, heater, or
radiator.
Avoid installing your refrigerator in humid
places (like next to sinks).
LEVELING
Place your refrigerator on a floor strong
enough to support it when fully loaded.
Make your refrigerator stand level by
adjusting the legs provided in case of
uneven floors.
Preparation and Operation
Before loading foods in your refrigerator:
1. Place all the racks and any kind of
vessels on their proper places,.
2. if required, perform necessary cleaning.
3. Open the door of your refrigerator and
any covers inside it for a period ot
time so as to aerate it.
4. Plug in the unit before checking for
current presence in the socket.
5. Set the thermostat button to the
highest position, then close the door
and the covers.
6. Keep the unit operational in this setting
for not less than one hour.
7. Then you can place foods inside the unit.
8. Afterwards, set can the thermostat
button to any position you require.
In doing this, consilder information in
the section titled "Temperature
adjustment" (Setting the controls).
Your refrigerator has only one control for
regulating the temperature in the fresh food
and in the freezer compartment. It is
located on the upper right side of the lower
section.
When the refrigerator is plugged in for the
first time, set the control to 3. Temperature
control adjustments range from 1 (warmest)
to 6 (coldest).
In a day or two, you may decide if the
control is set correctly. The setting indicated
above should be correct for normal,
household refrigerator usage. If you usé the
freezer section often, set the control to 6.
The number six setting is recommended for
short term usage only. The controls will be
set correctly when milk or juice is as cold as
you like and when ice cream is firm.
USE OF THE ICE CUBE TRAYS
An ice box is supplied together with an ice
tray. For your Ice requirements, fill
approximately 3/4 of the tray after having
washed it.
To eject ice cubes into the bucket provided,
insert the ice tray and twist slightly until the
pieces of ice fall.
If cubes are not used, they may shrink. The
longer cubes are stored, the smaller they
get.
¿aw
FIGURE 2