Amerec 3K User Manual
Amereo, Amerec steambath generators, Models; ak4, ak5, ak6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

AMEREO
AK and 3K Series with R30K Controi Owners Manual
AMEREC STEAMBATH GENERATORS
(MODELS; AK4, AK5, AK6,
AK7,
AK8.5, AK10,
3K8,
3K10, 3K12, 3K14)
SAVE THIS MANUAL
Thank you for purchasing your new AMEREC steam generator. If we can be of any assistance do
not hesitate to cai! our Service Department at 1-800-331-0349.
FOR THE SAFETY OF YOU AND YOUR FAMILY PLEASE READ THE WARNINGS TO
THE RIGHT AND ALL INSTRUCTIONS BEFORE USING YOUR STEAMBATH.
POST”STEAMBATH INSTRUCTIONS” LABEL OUTSIDE STEAMBATH FOR SAFETY
WARNINGS.
SECTION 1 : OPERATION OF YOUR NEW AMEREC GENERATOR
1. Assure that both the power circuit and water 
suppiy to the generator are ON
2. To activate the steam press the controi on. In 10 
to 20 minutes the room shouid be comfortable enough 
to begin taking a steam bath. The unit wit! turn off 
automatically in 30 minutes. The average time spent 
taking a steam bath is approximately 10 minutes.
3. Remove clothing and jewelry.
4. Enter the steam room and close the door to prevent
steam from escaping
5. Relax and enjoy the warm steam releasing tense
muscles and refreshing the entire body
6. If your steam room has a shower, a pleasant 
experience can be achieved by taking a warm shower 
while in the steam. You will find the contrast from 
water to steam quite invigorating
7. Pressing the control while the steam generator is 
operating will shut it off
8 The R30K control does not provide automatic 
temperature control. Use the on/off button to controi 
the temperature as desired
SECTION 2: MAINTENANCE OF THE AK SERIES
The steam generator, steam head, fittings and plumb
ing connections should be inspected annually for
water leaks and damage
The AK steam generator is equipped with a drain 
valve forflushing sediments from the generatortank. 
This procedure should be scheduled monthly or 
more often depending on local water conditions and
steam bath usage
FLUSHING PROCEDURE
1. The generator should be cool
2. Turn control on.
3 Open the drain valve.
4
The unit will drain without heating the water
5. Allow the water to run 10 minutes
6 Close the drain valve
WARNING
Electric Shock Hazard
-
High voltage exists
within this equipment There are no user
serviceable parts in this equipment All 
installaiion and service to this equipment 
should be performed by qualified licensed 
personnel.
Do not exceed 30 minutes in a steambath. 
Excessive exposure can he harmful to your 
health. Excessive exposure can produce a
rapid puise, iight-headedness, weakness
or fainting, if you become uncomforlahle 
or experience any of the above conditions 
exit the steambath immediately.
Steambaths can put undue stress on the 
body. Therefore a steambath should be 
used only under a doctors direction if you: 
Are pregnant
Have a heart condition 
Have high blood pressure 
Have circulatory problems 
Are under the influence of alcohol 
Are under the influence of drugs 
Have diabetes
Are under the care of a physician 
Are in generally poor health
Children shouid only use the steambath
under close aduit supervision.
Scald Hazard: Do Not Touch the steam
head or trim during operation as they are
HOT. Stay at least 12 inches away from the
hot steam escaping from the steam head. 
It is recommended that the steambath not 
be operated for more than one timer cycle 
wiihoutaitowing the steam hath enclosure
to cool because of the following:
Certain construction materials may be 
damaged by the higher than normal heat.
A scald hazard could be presented by bath
fixtures overheating.
Be careful when entering a steambath. 
Escaping steam from an overheated steam 
room may cause injury.
«09-38 9-15-04
