NewAir AI-210 Series User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION 5
OPERATING YOUR ICE MAKER
1. Open the cover, remove the ice basket and pour water into water reservoir. Keep water level
below the level mark.
2. Plug the unit into an applicable power supply outlet.
3. Press POWER button on the control panel to start the ice making cycle.
4. Select desired ice cube size by pressing the SELECT button, if room temperature is below
60“F, select the small ice size to avoid ice sticking together.
5. The ice making cycle take approximately 7 to 13 minutes, depending on the size of the ice
cube selected. (When operating in extremely hot conditions, the time may vary.)
6. When the ice maker is running, check the WATER INDICATOR periodically. If water pump
6
can't inject water, the ice maker will stop and the □ symbol will be flashing in the LCD
window. If this occurs, press POWER button to stop the unit. Unplug power source and fill
water into the reservoir up to the level mark. Plug in power source and press POWER button
again to start the unit. When the unit is powered off, please allow 3 minutes before turning the
unit back on. This will allow the refrigerant to settle.
7. The ice maker will automatically stop when the ice basket is full. The symbol will be
displayed in the LCD window.
8. Change water in the reservoir every 24 hours to ensure a reasonable hygiene level. Unplug
and drain water if unit will not be used for a long period of time.
9. Verify the water level periodically. The red “add/water” LED light will tight up when there is no more
water in the reservoir. The Ice Maker will stop automatically when there is no more water. Press the
“Power” button to stop the ice-making function. Refill the Ice Maker with water (see Step 2). Press
the Tower" button to restart the ice-makii^g function.
10.
When the Ice Maker is finished making ice, press the “Power” button to stop the ice-making function.
11 .Once completely finished making ice, unplug the unit and open the drain cap to drain out any excess
water from the unit. Wipe down the Ice Maker and store in an appropriate place.
£T/8:36ed
599000Sl7TiT:Oi
d3iUM ^
l?9:£0 i009-G9-Nnr