Avanti WC1000 - Manual (Page 10)

Moving Your Wine Cooler
Remove al! the bottles.
Securely tape down all loose items inside your wine cooler.
Turn the leveling screws up to the base to avoid damage.
Tape the doors shut.
Be sure the wine cooler stays in the upright position during transportation.
PROBLEMS WITH YOUR WINE COOLER?
You can solve many common wine cooler problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
TROUBLESHOOTING GUIDE
¡ r é
j PROBLEM
1
POSSIBLE CAUSE
• Wine coaler does not operate. Not plugged in.
The circuit breaker tripped or blown fuse.
; Wine coolers not cold enough" 'i Check the temperature control setting,
Ì External environment may require a higher
I setting
I The door is opened too often,
j
The door is not closed completely.
The door gasket does not seal properly.
The wine cooler does not have the correct
1 clearances.
Compressor turns on and off frequently. r he room temperature is hotter than normal.
A large amount of contents has been added to
the wine cooler.
The door is opened too often.
The door is not dosed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
The wine cooler does not have the correct
clearances.
Vibrations. Check to assure that the wine cooler is level.
The wine cooler seems to make too much noise. The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
wine cooler.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The wine cooler is not level.
i he door will not close properly. The wine cooler is not level.
The gasket is dirty.
The shelves are out of position.
9