Craftsman 316.79194 User Manual

Page 5

Cutting

Attachment Shield

Fuel

Cap

Throttle

Control

D-Handle

HassleFree™

Shaft Grip

Primer

Bulb

Oil Fill Plug

Cold

Starting

Lever

Spark Plug

Shaft

Housing

Starter

Rope

Grip

Line

Cutting

Blade

Muffler

Craftsman®

Convertible™

Coupler

On/Off Stop

Control

KNOW YOUR TRIMMER

Air Filter

Cover

ASSEMBLY INSTRUCTIONS

ADJUSTING THE D-HANDLE

Loosen the screws on the D-handle (Fig. 1).

While holding the unit in the
operating position (Fig. 2), position
the D-handle to the location that
provides you the best grip.

Tighten the clamp screws evenly,
until the D-handle is secure.

INSTALL LINE TRIMMER
ATTACHMENT

NOTE: To make installation easier, place

the unit on the ground or on a
workbench.

Turn knob counterclockwise to loosen
coupler (Fig. 15, p. 8).

While firmly holding attachment, push
it straight into the coupler until the
release button snaps into the primary
hole (Fig. 16, p. 8).

NOTE: Aligning the release button with the guide recess (Fig. 16,

p. 8) will help installation.

Turn the knob clockwise to tighten.

LINE TRIMMER APPLICATIONS
Cutting grass and light weeds; edging; and decorative trimming
around trees, fences, etc.

Fig. 1

(4) Screws

Shaft Grip

Shaft

Housing

On/Off Stop Control

Minimum 6 Inches

(15.24 cm)

D-Handle

Bottom Clamp

Fig. 2

Trimmer

Attachment

WARNING:

DO NOT ATTEMPT TO USE THIS UNIT

UNTIL THE D-HANDLE HAS BEEN ROTATED INTO
OPERATING POSITION (Fig. 1).