Harbor Freight Tools Model 65041 - Manual (Page 2)

SKU 65041 For technical questions, please call 1-800-444-3353. Page 2
Keep bystanders, children, and visitors 3.
away while operating the tool.
Obey the manual for the truck cab air com- 4.
pressor used to power this tool.
Stay alert. Use common sense. Do not 5.
use the tool while tired or under the influ-
ence of drugs, alcohol, or medication.
tool use and care
Do not use the Air Blow Gun if the Trigger 1.
Lever does not turn the tool on or off. Repair
before further use.
Disconnect the Air Blow Gun from the air 2.
source before adjusting, or storing the tool.
air source
1. Never connect to an air source
that is capable of exceeding
200 psi. Over pressurizing the
tool may cause bursting,
abnormal operation, breakage
of the tool or serious injury to persons. Use
only clean, dry, regulated compressed air at
the rated pressure or within the rated pres-
sure range as marked on the tool. Always
verify prior to using the tool that the air
source has been adjusted to the rated air
pressure or within the rated air-pressure
range.
Never use oxygen, carbon dioxide, com- 2.
bustible gases or any bottled gas as an
air source for the tool.
Service
Tool service must be performed only by 1.
qualified repair personnel using only identi-
cal replacement parts .
assembly
NOTE: If you do not feel qualified to safety install 1.
this Air Blow Gun, have it installed by a qualified
technician.
NOTE: Tools Needed: Two small adjustable 2.
wrenches, small metal saw.
Make sure both the truck engine and auxil- 3.
iary generator is shut down.
Follow manufacturer’s directions for locating 4.
the truck cab air line. Usually it is located
behind the drivers seat.
Cut the truck cab air line and install the T- 5.
Fitting (2) as follows:
Remove the nuts on the two ends of the T- a.
Fitting body.
Slide the Compression Sleeves out of the
b.
T-Fitting body. Slide an end of the truck cab
air line through a nut and Compression
Sleeve and into openings on the T-Fitting
body.
Thread the nuts onto the T-Fitting body and
c.
tighten snugly. This will compress the Com-
pression Sleeves and seal the air line.
The procedure is the same as laid out in
d.
steps (a) through (d) for attaching the Truck
Cab Air Blow Gun line.
caution: Make sure all air line fittings are not
leaking when the generator(s) are operating.
They may be connected to other needed ac-
cessories.
general operating instructions
caution! do not exceed maximum air pres- 1.
sure rating of 90 pSi.
warning: never direct the air blow gun at 2.
your skin, or any person or animal.
Attach Air Gun (4) by threading onto air line. 3.
Thread on the Precision Tip for blowing out small 4.
areas or cracks, or the Booster Tip for wide areas.
Point the Air Gun and squeeze the Trigger Lever. 5.
When finished, Release the Trigger Lever to stop 6.
the air flow.
Leave the Air Blow Gun hooked up and coiled 7.
under the drivers seat of the truck cab when not
in use.
cleaning, maintenance
Periodically wipe down entire length of Air Line and
inspect for leaks. If any are found, replace Air Line; DO
NOT repair.