Vom-783t operations manual – ASA Electronics VOYAGER VOM-783T User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

VOM-783T OPERATIONS MANUAL
FUNCTIONS AND OPERATION
Front of Monitor : See FIGURE 4
1. Power switch : STAND- BY Monitor operates when vehicle transmission is switched into
"REVERSE" ON - monitor and system operate when ignition switch is "ON"
2. Camera selection : "CAT' used mainly for rear mounted camera or as specified by the installer.
"CA2" & "CA3" and used mainly for side or mirror mounted camera or as specified by the installer.
3. Tilt up/ down switch : Vertical angle or view adjusted into Up and Down positions.
4. Day/ Night switch : Pre-set brightness and contrast levels optimized for day or night operation.
5. Contrast
: Variable control of contrast. Should be adjusted if the "DAY/ NIGHT"
switch does not achieve the most desirable picture.
6. Brightness
: Variable control of brightness. Should be adjusted if the "DAY/ NIGHT"
switch does not achieve the most desirable picture.
7. Volume
: Variable control of internal speaker volume and output audio level.
FUNCTIONS AND OPERATION CONTINUED
Rear of monitor : See FIGURE 4
8. POWER CONNECTION :
(6) (5^ (о)
(6) (5) (4)
(3) (2) (О)
Pin No.
Description
I
Power ( DC lOV ~32V)
2
Trigger3 (DC 12V ~24V)
3
Ground
4
N/C
5
Trigger I (DC 12V~24V)
6
Trigger2 (DC 12V~ 24V)
VOM-783T 5