Aiwa CT-X411YU - Manual (Page 3)

THEFT PROTECTION
Take the front panel with you when leaving the car, and
keep it in the supplied carrying case.
Detaching the front panel
Before detaching the front panel, remove the cassette to
prevent possible damage to the unit.
1 Press Z to remove the cassette.
2 Press and hold PWR/MUTE until the unit turns off.
3 Press %. (Hold the panel with one hand to prevent
accidentally dropping it.)
4 Remove the panel.
BASIC OPERATION,
AUDIO AND CLOCK
ADJUSTMENT
SEL DISP
Attaching the front panel
1 Engage the left side of the front panel to the left catch
on the unit.
2 Push the panel forward until it locks. Be sure not to
press any buttons while you are attaching the panel.
Note
Do not touch the front panel connector. This could cause
a poor or faulty connection.
Security lamp
The security lamp will continue to flash while the front
panel is detached from the unit.
Turning the unit on/off
• Press PWR/MUTE to turn on the unit. The unit also
turns on when you insert a cassette.
• Press and hold PWR/MUTE until the unit turns off.
Note
Most operations described in this manual require
the unit to be turned on before starting the operation,
unless explicitly stated otherwise.
Changing the source mode
1 Press FNC.
Pressing FNC cycles through source modes in the
following order:
|—^FM^FM^FM^AM1 —
I
I— -
' raiEi
TRPE ^ AM2^-—I
Adjusting the volume
1 Turn the Smart Jog.
VOL (volume)
indicator flashes.
Muting the sound
1 Press PWR/MUTE briefly.
To restore volume, briefly press PWR/MUTE again.
m
z
Q
CO
X
* Tape Play mode (available while a cassette is in the
unit)
ENGLISH
2