Care & maintenance, General recomandation, Enamelled parts – Avanti DER241BS User Manual
Page 14: Stainless steel elements, Inside of oven, Replacing the oven light, Care and maintenance -16, Warning very important
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/724080/14/background.png)
CARE & MAINTENANCE
WARNING
VERY IMPORTANT
Before any operation of maintenance
disconnect the appliance from the
electrical mains supply.
piDpinotiUse;^^^
bbecau^PTittei
^■I't: dàngërOUiS^-T-’;-';
GENERAL RECOMANDATION
✓ Important: Before any operation of cleaning and maintenance disconnect the
appliance from the electrical supply.
/ it is advisable to clean when the appliance is cold and especially for cleaning the
enamelled parts.
/ Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the
surfaces.
/ Avoid using cleaning products with a chlorine or acidic base.
The oven must always be cleaned after every use. using suitable products and
keeping in mind that its operation for 30 minutes on the highest temperature
eliminates most grime reducing it to ashes.
ENAMELLED PARTS
All the enamelled parts must be cleaned with a sponge and soapy water only or
other non-abrasive products.
/
Dry preferably with a chamois leather.
If acid substances such as lemon juice, tomato conserve, vinegar etc. are left on
the enamel for a long time they will etch it, making it opaque.
STAINLESS STEEL ELEMENTS
/ Stainless steel parts must be rinsed with water and dried with a soft and dean
cloth or with a chamois leather.
/ For difficult dirt, use a specific non-abrasive product available commercially or a
little hot vinegar.
INSIDE OF OVEN
This must be cleaned regularly.
With the oven warm, wipe the inside wails with a cloth soaked in very hot soapy water
or another suitable product.
REPLACING THE OVEN LIGHT
Before any maintenance is started involving electrical parts of the appliance, it must be
disconnected from the power supply.
- Let the oven cavity and the broil element cool down;
- Switch olf the electrical supply:
- Remove the protective cover;
- Unscrew and replace the bulb with a new one suitable for high temperatures (300“C-
STO^F) having the following specifications: 120V 60 Hz, 15W, E14
- Refit the protective cover.
NOTE: Oven bulb replacement is not covered by your warranty.
14