BUSH TR130 - Manual (Page 2)

Getting started
Thank you for purchasing your
new Bush product.
Remove your Bush TR130 carefully
from the box. You may wish to
store the packaging for future use.
Adjusting the sound
Rotate the Volume control to set
the sound level.
The Tone control can be adjusted to
your personal preference.
Read these instructions before use. HeodphoneS
Switching on
Mains power
Insert the mains power cord into the socket
on the rear of the unit.
Connect the 3-pin mains plug into the mains
socket and switch on.
Please Note
When not in use, disconnect the 3-
pin plug from the mains power and
the power cord from the unit.
Batteries
To use battery power, ensure the mains lead is
removed from the AC socket. Remove the
battery compartment cover.
Fit 6 X C size battery (not supplied)into
the compartment.
Refit the battery compartment cover.
Plug your headphones into the
Headphones
socket on the side of
the unit.
Headphones should have a 3.5mm
diameter stereo plug and a
impedance of 8-32 ohms.
When headphones are connected,
the speakers are automatically
disconnected.
Using the radio
Tuning
Rotate the Volume control to turn
the unit on.
Select the desired frequency band
(FM, MW and LW) using the.Band
selector
buttons.
Tune to the desired radio station by
turning the Tuning control until the
white line coincides with the correct
frequency on the scale.
Aerial
For reception the signals are picked up
through the built-in antenna. You may have
to move the radio to obtain the best
reception.
To turn the radio off
Rotate the Volume control towards
the off position until it clicks.