Aiphone MYW-CA User Manual
Myw-ca, Alphone, Pantilt separate camera adaptor
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
83070400
1092
@
® AlPHONE
PanTilt Separate Camera Adaptor
Model;
V
MYW-CA
(Camera adaptor)
J
INSTALLATION MANUAL
MYW-CA is a surface-mount box for attaching MY-CA PanTilt video door station inside,
so that MY-CA can work as surveillance camera.
INSTALLATION — How to mount MY-CA into MYW-CA
1. Removing the MY-CA chassis;
Loosen the tamper-proof screw on front case, and remove
the back frame. Unscrew at one point, and open the chassis.
Pull off CN102 connector, and then reattach the chassis.
When reattaching the
chassis, be careful that
the weather-stripping
(string) should rest
attached.
MY-CA
-WEATHER
STRIPPING
INSIDE CHASSIS
WEATHER-STRIPPING
BACK FRAME
MY-CA
2. Connecting two leads to MY-CA;
Locate the MY-CA unit inside the MYW-CA box.
Connect two black and white leads to AI, A2
terminals on MY-CA.
Wiring is non-polarized.
Attach back plate with all 6 screws securely.
SCREW (6)—
(supplied)
BACK PLATE
Remove a seal on camera cover before mounting MY-CA.
Be careful not to scratch the cover surface.
To clean, use soft cloth.
3. Installing the MYW-CA unit;
This shows an installation example of MYW-CA camera unit,
along with lE-JA audio door station, and DP-600Z motion detector.
At the entry (under the eaves)
CAMERA UNIT
TAMPER-PROOF
SCREW
COVER
CN102
MY-CA
(without back frame)
BLUE
YELLOW
RED
BROWN
BLACK
WHITE
(Each pair wiring is non-polarized)
to; Main video monito!
!■ to; Audio door station
to; Motion detector
MOTION DETECTOR
DP-600Z (Instructions
furnished with
DP-600Z)
WOOD
SCREW (4)
Adjust MYW-CA direction
with these 2 screws and
the center hexagonal bolt.
INSIDE THE HOUSE
6-wire cable
(approx. 1.5m/5‘ long)
TERMINAL BOARD
(locally available)
or WIRE NUTS
The MYW-CA cable should be "U"-shaped
to allow easy run off of water, etc.
AUDIO
DOOR STATION
lE-JA
!ito
Mounting accessories;
Attach the mounting base with 4 wood screws, and the
arm with hexagonal bolt.
WOOD SCREW (4)
HEXAGONAL BOLT
& WASHER
SCREW & WASHER (2)--------
and SCREW (6) for back plate
As shown, mount the MYW-CA unit to the hardware supplied.
Provide a terminal board locally available, on which connect wires from main video monitor, motion detector & door station.
Water-proof the junction parts of the cable, if exposed.