Avanti 398VFYW - Manual (Page 7)

Electrical Connection
H Warning H
Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged, have it replaced by an
authorized Avanti Products service center.
This freezer should be properly grounded for your safety. The power
cord of this freezer is equipped with a three-prong plug which mates
with standard three prong wail outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third ground prong
from the power cord supplied
Use of the extension cord is not recommended.
This freezer requires a standard 115 volt, 60Hz electrical outlet with
three-prong ground. The cord should be secured behind the freezer
and not left exposed or dangling to prevent accidental injury.
> Reversing the Door Swing of Your Freezer
This freezer has the capability of either opening the door from the left or
right side. The unit is delivered to you with the door opening from the left
side. Should you desire to reverse the opening direction, please follow these
instructions.
NOTE:
All parts removed must be saved to do the reinstallation of the door.
Reversal and Installation of the Freezer Door
• Remove the two screws(1 )that hold the lower hinge{2)(right side)to the
frame. Also, remove the screw-type leveling front leg(3).
• Remove the left front ieg{4) and transfer it to the right side.
• Lift the door and place it on a padded surface to prevent scratching it.
Make sure to remove the spring(5) located inside the upper right hole
of the door and the upper right side pin{6).
• Remove the plug button(7)from the upper left hole of the door and
transfer it to the uncovered hole at the right side. Be sure to press the
button firmly into the hole.
• Insert the upper pin(6) previously removed from the right side (step 3)
and transfer it to the other hole at the left side of the top frame.
• insert the spring(5)previously removed(step 3)inside the upper left side
hole of the door.
• Set the door in its place making sure the pin(6)enters the bushing at
the lower upper frame section(hole).
• While holding the door in the closed position, secure the lower left
hinge(2)previously removed(step 1).Before placing this lower hinge,
remove the upper bolt-pin(8) and reverse the direction of the hinge.
• Insert the boit-pin(8)and do not tighten until the top of the door is
leveled with the counter top.
• Insert the two screws(1)previousfy removed(step 1)and tighten them.
-6
-