To stop engine, Adjustments, Carburetor adjustment – Bolens 692 and 693 User Manual
Page 4: Two-way discharge, Height adjustment, Maintenance, Lubrication, Engine
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/723747/4/background.png)
TO STOP ENGINE
1. To stop engine, move throttle control lever to OFF
position.
2.
Disconnect spark plug wire and ground to prevent
accidental
starting
while
equipment
is
un
attended.
ADJUSTMENTS
CARBURETOR ADJUSTMENT
A
WARNING: Do not at any time make any
adjustment to the unit without first stop
ping engine and disconnecting spark
plug wire.
TWO-WAY DISCHARGE
The leaf blower can be adjusted to discharge toward
the front of the unit or to the side. Simply push down
on the handle and swing door toward the front to dis
charge out the side, or to the side to discharge out the
front. See figure 5.
Directional
Discharge
FIGURE 5.
HEIGHT ADJUSTMENT
The height adjustment crank is located on the right
hand side of the leaf blower. See figure 6. Turn the
crank clockwise to raise the discharge chute. Turn the
crank counterclockwise to lower.
A
WARNING: If any adjustments are made
to the engine while the engine is running
(e.g. carburetor), keep clear of all moving
parts. Be careful of heated surfaces and
muffler.
Minor carburetor adjustment may be required to com
pensate for differences in fuel, temperature, altitude
or load.
NOTE:
A dirty air cieaner will cause engine to run
rough. Be certain air cleaner is clean and attached to
the carburetor before adjusting carburetor.
Do not make unnecessary adjustments. Factory set
tings are satisfactory for most applications and condi
tions. If adjustment is needed, refer to the separate
engine manual packed with your leaf blower.
MAINTENANCE
A
WARNING: Always stop engine and dis
connect spark plug wire before cleaning,
lubricating or performing any repairs or
maintenance.
FIGURE 6.
LUBRICATION
Wheels-Rear wheels are provided with light oil bear
ings. Place a few drops of SAE 30 oil on each bearing
once a season.
Directional Discharge-Lubricate the
spring and
the
pivot point on the door mechanism at least once a
season with light oil.
ENGINE
Refer to the separate engine manual for engine
maintenance instructions.
Maintain
engine oil
as instructed in the separate
engine manual packed with your unit. Read and follow
instructions carefully.
Service
air cleaner
every 25 hours under normal con
ditions. Clean every few hours under extremely dusty
conditions.
Poor
engine
performance
and
flooding
usually indicates that the air cleaner should be ser
viced. To service the air cleaner, refer to the separate
engine manual packed with your unit.
The
spark plug
should be cleaned and the gap reset
once a season. Spark plug replacement is recom
mended at the start of each season; check engine
manual for correct plug type and gap specifications.
Clean the engine
regularly with a cloth or brush.
Keep the cooling system (blower housing area) clean
to permit proper air circulation which is essential to
engine performance and life. Be certain to remove all
dirt and combustible debris from muffler area.