Remote control – AstroStart MV-801/802 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
mi80)l ^802
REMOTE CONTROL
Your remote control works off a small, long-life 12-volt alkaline battery
(GP-23A). The range of your remote control can be affected by a weak
battery, interference from nearby metal structures, hydro poles, or crowded
parking lots.
With its electronic CODE LEARNING feature, up to three additional remote
controls can be programmed for your vehicle. See your dealer for
replacement batteries or additional remote controls.
USING YOUR REMOTE CONTROL
To
ensure
that
commands
are
transmitted properly, press desired
button for 2 seconds. Indicator light will
flash momentarily while transmitting the
command.
A command will not be transmitted
properly if you do not hold the button
down long enough (i.e., until indicator
light goes out by itself).
Example: To start, press button "A" until
indicator light goes out.
CONFIRMING COMMANDS
Your system will acknowledge correct reception of a command by flashing
parking lights. In this manual, confirmation signals are written in an
abbreviated form; for example:
(lights: 2)
Means that parking lights will flash twice.