AEG OKO Favorit 645 - Manual (Page 21)

Information for the installer
Water discharge
At the rear of the machine the drain hose is
secured with plastic straps which must be re­
moved. Route the drain hose along the recess
provided at the rear of the dishwasher (fig. 3/b).
The outlet end of the hose is 19 mm diameter
and should fit any available sink trap connec­
tions and is secured by means of the hose
clip supplied.
Should you wish to hook the drain hose onto
a sink use the plastic hose holder supplied
with the machine. See illustration this page.
The holder has a hole to enable you to secure
the holder to the wall if the sink edge is too
wide, in this case thread a piece of string
through the hole and secure to the tap or wall
above the sink.
Your dishwasher is fitted with a water pump,
controlled by the programme to pump off the
water up a heigt of 1 m. Should it become
necessary to extend the drain hose, use only
original extension hoses. These are available
in length of 2.70 m and 4.0 m as spares from
your AEG Spare Parts Department. The pump
is capable of pumping water to a distance of
3 m horizontally, at a height of max. 85 cm
above floor level. The minimum height above
the base of the machine must always be
30 cm.
The internal diameter of the extension hoses
must be 19 mm to allow the machine to func­
tion correctly.
The recess at the back of the machine offers
sufficient space to accommodate the drain
hose for installation to the left or right of the
machine.
The drain hose must be at least 30 cm above
the base of the machine before It Is connect­
ed to any drainage system.
Important
When connecting the drain hose make sure
that It lies freely In the recess at the back of
the machine and is neither kinked nor twisted.
The drain hose can be hooked into a separate
stand pipe.
When connecting the drain hose to a sink trap
the internal diameter of the connection must
be 15 mm minimum.
The drain hose must not be connected to a
waste disposal unit
21