Electrical connection, Warning, Operating your freezer – Avanti CF102Y User Manual
Page 7: Temperature control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• Plug the appliance into an exclusive properly installed grounded wall outlet. Do
not under any circumstances cut or remove the third (ground) prong from the
power cord. Any questions concerning power and or grounding should be
directed toward a certified electrician or an authorized Avanti Products service
center.
> Electrical Connection
Warning
Improper use of the grounded plug can result in the risk of electrical shock.If the power
cord is damaged, have it replaced by an authorized Avanti Products service center.
This appliance should be properly grounded for your safety. The power cord of this
appliance is equipped with a three-prong plug which mates with standard three prong wall
outlets to minimize the possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord
supplied.
Use of extension cords is not recommended.
This appliance requires a standard 115/120 volt, 60Hz electrical outlet with three-prong ground.
The cord should be secured behind the appliance and not left exposed or dangling to prevent
accidental injury.
The Tower On "light indicates that the freezer is properly connected to the electrical power.
The light indicates power supply, and will glow even if the temperature control dial is turned to
"0",or the compressor has failed to work and the compartment is not being cooled.
1
The "Compressor On”light indicates that the compressor is on and running. The compressor
should not, under normal conditions,be. running continuously unless the unit is in" Fast Freeze”
mode.
OPERATING YOUR FREEZER
Temperature Control
•
Your freezer has one control for regulating the temperature . The temperature control is
located on the lower right hand corner.
•
The first time you turn the unit on, switch on the Fast Freeze switch (amber light) and
run for at least 8 hours before putting frozen foods inside. This will ensure the cabinet
is thoroughly chilled before food is put in.
• Turn off the Fast Freeze switch .
• The range of the temperature control is from position "1” the warmest to "7” the
coldest. Adjust the temperature control to the setting that best suits your needs.
The setting of "4” should be correct for home or office freezer use .
• To turn the freezer off, turn the temperature control to "0” .