Avoid service checklist – Arctic Air 297283501 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Avoid Service Checklist
Before calling for service, review this list. It may save yo« both time and expense. This list
includes common occurrences that are not the result of defective workmanship or materials in
this appliance.
OCCURRENCE
SOLUTIOM
APPLIANCE DOES NOT RUN
Д.ррНапсй may Ь
й
in dafrost сус1й , and the compr«ssot or fan vati not run.
T&mpeiatLiro cijntrol is in tlif iS'FF p'jsition.
Applianco may not Ь
й
pluqged in oi piluq may Ь
й
I
oos
&. B&
ыгй
plug is tightly
pushed into obctiical outl&t.
'
'
'
Fus&has blown, or circ uitbrakoi hostrippied. ChocCrosetcircuitbrootet or roplaci
fuse with I s amp. time delay lise.
Power outage. Check lights. Gall local etectiic company.
Appi ance runs t» much о г too
long.
Room OI outside weather is hot. It is noun al for the appi lance to work haiderunder
these conditions.
АррНапсй had rocontly been disconnected for a period of time. Appliance requires
24 hours to cool down completely.
Large amounts of '//aim oi hot food have been stored recentfy. '/‘/arm food will
cause the appliance to run more until the desired tenip>erature is reached.
Cioor is kepit open too long or tc>ofrequently. Wami air enters the appliance every
time the door is opened. Open the door less often.
Appliance door may te slightly орюп. SeeC'ccunence se:tion "Dcor Problems."
Temperature control is set too cold. Turn the control knob to a 7/arnier setting.
.Allow several hours foi the temperature tc« stabilize.
Appliance gasket is dirty, worn, cracked, or poorly fitted. Clean or change gasket.
Leaksin the door seal will cause appliance to run longer in orderto maintain desired
temperature.
Temperatures inside the
appliance are ico cold.
Temperature control is set too cold. Turn the control to a warmer setting. Alluw
several houro for the temperature to stabilize.
Temperatures inside the
appliance are too wami.
« Temperature con tool is set too '//arm. Turn the control to a colder setting. AJIo'/;
several hours for the temperature to stabilize.
* Door is kept open too long or is op-ened tc appliance every time the door is opened. Open the door less often. * [loor may be open slightly. See 'jccuirence section "Door Problems.’ * Large amounts of 'warm or hc>t food may have been stored recently. Wait until the appliance has had a chance to« reach its selected temperature. * Appliance has tec ently been disconnected for a period of time. Appliance requires 24 hours to cool dov/n completely. * The product internal iemperaiute will rise during the defi'ost cycle. Temperature of iitemal * Appliance cabinet is warm to the to warm air form the inside. 7
appliance surface is nann.