Clarity POWER P400 - Manual (Page 5)

5
SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
• Unplug this product from the wall
outlet and refer servicing to the
manufacturer under the following
conditions:
A. When the power supply cord
or plug is damaged or frayed.
B. If liquid has been spilled into
the product.
C. If the product has been
exposed to rain or water.
D. If the product does not
operate normally by following
the operating instructions.
Adjust only those controls that are
covered by the operating instructions
because improper adjustment of
other controls may result in damage
and will often require extensive work
by a qualified technician to restore
the product to normal operation.
E. If the product has been
dropped or the cabinet has
been damaged.
F. If the product exhibits a distinct
change in performance.
• Avoid using a telephone (other
than a cordless type) during an
electrical storm. There may be a
remote risk of electric shock
from lightning.
• Do not use this telephone to
report a gas leak in the vicinity of
the leak.
The following items are included as
part of the CS-03 Requirements.
The Load Number of the equipment
is 20.
The standard connecting arrange-
ment code for the equipment is
CA11A.
NOTICE: The Canadian
Department of Communications
label identifies certified equipment.
This certification means that the
equipment meets certain telecom-
munications network protective
operational and safety requirements.
The Department does not guarantee
that the equipment will operate to
the user’s satisfaction.
Before installing this equipment,
users should ensure that it is per-
missible to be connected to the
facilities of the local telecommunica-
tions company. The equipment must
also be installed using an acceptable
method of connection. In some cases,
the company’s inside wiring associ-
ated with a single line individual
service may be extended by means
of a certified connector assembly
(telephone extension cord). The cus-
tomer should be aware that compli-
ance with the above conditions may
not prevent degradation of service in
some situations.
Repairs to certified equipment
should be made by an authorized