Avanti mo629t - Manual (Page 11)

1 .
2
.
3.
4.
5.
6
.
7.
8 .
OPERATION PROCEDURE
• Plug the power supply cord into a standard 3-pronged 16 Amp, 120v AC 60 Hz
• After placing the food in a suitable container, open the oven door and put it on the
glass tray. The glass tray and roller guide must always be in place during cooking.
• Shut the door. Make sure that it is firmly closed.
When the oven door is opened, the light turns on.
The oven door can be opened at any time during operation by pressing the door release button
on the control panel. The oven will automatically shut off. To restart the oven, close the door and
then touch START.
Each time a pad is touched, a BEEP will sound to acknowledge the touch. One of the function
pads must be touched before the number pads. Therefore, no beep will sound if the numeral pad
is touched before the function pad.
The oven automatically cooks on high power and defrosts on low power.
The display will flash “1:01” when the oven is plugged in. After 1 minute, the display wilt change.
Time of day clock returns to the present time when the oven turns off.
When the CANCEL pad is touched during the oven operation, the oven stops cooking and all
information is erased. If the oven door is opened during the oven operation, all information is
retained.
if the START pad is touched and the oven does not operate, check the area between the door
and door seal for obstructions and make sure the door is closed securely. The oven will not start
cooking until the door is completely dosed and the program has been set.
CARE AND MAINTENANCE
Cleaning Your Appliance
Turn the oven off and remove the power plug from the wall socket before deaning.
Keep the inside of the oven clean. When food splatters or spilled liquids adhere to oven wails,
wipe with a damp cloth. Mild detergent may be used if the oven gets very dirty. The use of harsh
detergent or abrasives is not recommended.
The outside oven surfaces should be cleaned with a damp cloth. To prevent damage to the
operating parts inside the oven, water should not be allowed to seep into the ventilation openings.
Do not allow the control panel to become wet. Clean with a soft, damp doth. Do not use
detergents, abrasives or spray-on cleaners on the control Panel, When deaning the control
Panel, leave oven door open to prevent oven from accidentally turning on.
If steam accumulates inside or around the outside of the oven door, wipe with a soft cloth. This
may occur when the microwave oven is operated under high humidity conditions and in no way
indicates malfunction of the unit.
it is occasionally necessary to remove the glass tray for deaning. Wash the tray in warm sudsy
water or in a dishwasher.
The roller ring and oven cavity floor should be cleaned regularly to avoid excessive noise. Simply
, wipe the bottom surface of the oven with mild detergent, water or window cleaner and dry. The
roller ring may be washed in mild sudsy water or dishwasher. Cooking vapors collect during
repeated use but in no way affect the bottom surface or roller ring wheels. V^fhen removing the
roller ring from cavity floor for deaning, be sure to replace it in the proper position.
Remove odors from your oven by combining a cup of water with the juice arid skin of one lemon
in a deep microwavable bowl. Microwave for 5 minutes. Wipe thoroughly and dry with a soft
cloth.
When it becomes necessary to replace the oven light, please consult a dealer to have it replaced.
f!
11