Bryant 5-905 - Manual (Page 2)

regulate humidity to "high," "Ipw^;" or "off" position.
To mount the adapter package:
r. Remove the door bn the motor side. '
2. Remove baffle, and place the adapter flush against
the area to which it is to be installed.
3. With a pencil, mark the mounting holes and the access
hole. Remove the adapter package, drill¿the marked
holes (1/8" drill). Cut out the access hole in the
plenum or furnace casing. Mount the adapter with (k)
screws provided. Slide humidifier into adapter and
replace baffle. (Make sure baffle top is towards
side access hole.) Fasten doors with screws provided.
Bypass piping from the adapter to the duct should have a diameter of 6".
The humidifier is factory assembled as a right-hand unit for installation on
the right-hand side of the furnace or plenum. To make a left-hand unit, re-
mbve the float .assembly and re-assemble on. the-left-hand side of the tray.
39905D1
Figure 2 Installation on Side of Furnace
-2-