Avanti WC260YGW/B - Manual (Page 5)

hinge ) on the right side.
• Remove the adjustable leveling leg(8) and transfer it to the right side.
• Reattach the lower hinge(4) on the left side by attaching the adjustable
leveling leg (8) and two bolts (7).
Reversal and Installation of Wine Cooler Door
• Set the
enters
• While
hinge u
the upp
• Before
cabine
• Repla
• Replad
corner
• Chang
Changinc
wine cooler door in its new position, making sure the hinge Pin
Ihe bushing at the bottom of the cabinet.
holding the door in the closed position, loosely secure the upper
sing the two Phillips screws. Be sure the pin enters the bushing at
er and lower frame section (holes).
tightening the screws, be sure the top of the door is level with the
top.
the upper hinge cover(1).
e the two plug buttons(IO) in the holes now on the top right
of the unit.
3 the position of the handle
the Position of the Handle
ce
doo
• Remov
• Place
the
• Reattat
NOTE:
Before ti
the top
^ Temperature Control
• The firs
positior
• The s
and
" nor N i
flee wir
• To turr
NOTE:
• Turning
but doE
• If the
e the two Phillips screws attaching the handle.
Ihe handle over the two holes located on the upper right corner of
r.
h using the two Phillips screws.
ightening these screws, make sure the top of the door is level with
or the cabinet.
OPERATING YOUR WINE COOLER
t time you turn thè unii on . set thè temperature control to "MAX”
eltings of the temperature control are“OFF”, “MIN”, "NORMAL"
ryiAX” . After 20 minutes, adjust the temperature control setting to
AL". The setting of'NORMAL" should be correct for home or of-
e cooler use.
the wine cooler off, turn the temperature control to“OFF”.
the temperature control to“OFF”position stops the cooling cycle,
■s not shut off the power to the wine cooler.
Onit is unplugged, power lost, or turned off, you must wait 3 to 5
minutes before restarting the unit. If you attempt to restart before this
time delay, the wine cooler will not start.
•The range between“M!N”and“MAX”is from 48°F to 61 "F, which is ideal
for the storage of wines at the " NORMAL" setting.
CARE AND MAINTENANCE
^ Cleaning Your Wine Cooler
• Turn the temperature control to‘‘OFF”, unplug the wine cooler, and re­
move the bottles.
• Wash the inside with a warm water and baking soda solution. The solu­
tion should be about 2 tablespoons of baking soda to a quart of water.
• Wash the shelves and trays with a mild detergent solution.
• The outside of the wine cooler should be cleaned with mild detergent and
warm water.
• It may also be necessary to periodically wipe the bottom part of the
storage area, as the wine cooler is designed to retain humidity, and
condensation may collect there.
• Dry the water collection tray located above the compressor in the back of
the unit. Once dry, place it back to its original position.
^ Maintenance of Your Wine Cooler
• Power Failure
Most power failures are corrected within a few hours and should not affect
the temperature of your wine cooler if you minimize the number of times
the door is opened. If the power is going to be off for a longer period of
time, you need to take the proper steps to protect your contents.
^ Vacation Time
During long absences, remove ail the bottles; unplug your wine cooler,
clean your wine cooler, and leave the door open slightly to avoid possible
formation of condensation, mold, or odors.
^ Moving Your Wine Cooler
• Remove all the bottles.
• Securely tape down all loose items inside your wine cooler.
• Turn the leveling, screws up to the base to avoid damage.
• Tape the doors shut.
• Be sure the wine cooler stays in the upright position during transportation.