Temperature control, Defrosting your freezer – Avanti VM399W User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 1 (Position prior to door reversal)
FIGURE 2 (Position after door reversal)
1 Upper Pin
2 Pin Cup
3 Lower Door Hinge
4 Washer
5 Boit-pin
6 Leveling legs
7 Door Hinge Screws
OPERATING YOUR FREEZER
Temperature Control
• The temperato re'control is located underneath the countertop on the front side of the cabinet.
• The first time you turn the unit on set the temperature control to the majdmum position, using
the thermostat key provided. (If the key is misplaced you may also use a coin or flathead
screwdriver.)
• The range of the temperature control is from position" W" the warmest to “C” the coldest. After
24 to 48 hours, adjust the temperature control to the setting that best suites your needs. The
setting of “M” should be correct for home or office freezer use.
• To turn the freezer off, turn the temperature control to "OFP
NOTE:
■ Turning the temperature control to "OFF" position stops the cooling cycle but does not shut
off the power to the freezer.
■
If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the freezer will not start.
Defrosting Your Freezer
When? For the most efficient operation and minimum energy consumption, defrost the freezer
compartment when the frost on the freezer walls is excessive or
%
inch thick.
How? To start defrosting, turn the temperature control to "OFF, unplug the freezer, remove the
food and baskets. After the frost or ice has melted, discard the melted water and dry up the
interior of refrigerator. Then the freezer can be restarted by a turning its thermostat to the
desired setting.