Clean your unit during regular use – NewAir AI-400 Series User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CLEAN YOUR UNIT DURING REGULAR USE

After you have used your unit for three or more months, we suggest cleaning the unit again.

Unplug your unit before doing any cleaning or maintenance!

•

For the outside enclosure of the unit, wash with a soft, wet cloth and liquid dishwashing soap.

Do not use corrosive chemical solvents as this might cause color changes and hurt the

machine. Do not pour water over the whole shell when washing, and avoid getting the

electrical parts wet.

•

For the hot and cold water dispenser, twist the bottle receptacle of the non-spill system (smart

device) counterclockwise and pull it up.

Take apart the non-spill system (smart device and smart core showed in above figure), and

proceed to wash it with the dishwashing fluid, rinse, and reassemble. Empty both tanks (hot and

cold) by unplugging the drain cap of the hot water tank at the back of the unit. Next, clean the

inside parts of the water dispenser system with vinegar or a 2% citric acid solution to remove

mineral scaling from the water. Rinse well, and then open the drain cap from the hot water tank to

remove all of the water. Replace all of the parts and securely fasten the drain cap. It is

important to let the unit dry for two hours before plugging it back in. When finished, reinstall the

bottle receptacle (smart device).

•

• For the ice-making chamber, remove the ice and water separator and the ice storing plate by

unscrewing the screw according to the following figure.