Changing reversible doors – Avanti 1133YW User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Changing Reversible Doors:

This refrigerator has been built with the door hinges on the right. If you wish to change
the opening direction, follow instructions below.

1- Remove the upper rounded top (1). Using a sharp object, pry out the (2) plug buttons

and remove the 2 PHILLIPS screws (2). Remove the 2 PHILLIPS screws (3) which con
nect the uppeer hinges to the upper rounded top and place it on a padded surface to
prevent scratching,

2- Remove the bolts (4) of the upper hinge. Careftjiiy lift the door (5) and place it on a
padded surface to prevent scratching.

Before changing the direction of the evaporetor lid. remove the meat keeper and the

drip tray. After completing this operation replace the drip tray and the meat keeper to
their places.

3- Push the shaft of the freezer section door up by means of a screwdriver.

4- At this position take the freezer section, door out (6).

5- Place the freezer section door (7) in its new place by turning it opposite of the pre
vious position.

6- Remove the kick plate (8) by taking out the screws at each side of it with a Phillips
screwdriver.

7- Remove the lower hinge (9) from the right side and transfer it to the left end.

8- nt the kick plate (10) into its place.

9- Remove the door handle (11) by taking out the screws. Remove the plug buttons and
transfer them to the other side (12).

10- Mounth the door handle (13) to the other side.

11- Set the door (14) to its place making sure the hinge pin enters the bushing in the

door bottom section.

12- While holding the door in the closed position, loosely secure the upper hinge (IS)

using the bolts removed in STEP 2.

13- Before tightening these bolts, make sure the top of the door is level with the cabinet

tp. Avoid over-tightening these bolts. Tighten both until they are just snug, then turn an

other one-haif turn.

14- Replace the upper rounded top (16).

15- Tghten the upper rounded top screws (17) and press the plug buttons (18).

16- Fit and tighten the screws (19) which connect the upper hinges to the upper round

ed top.