Avanti CF49 - Manual (Page 2)

OPERATING INSTRUCTIONS
The Freezer must be allowed to stand with the lid open for a pderiod of at least 12
hours after delivery before it is switched on. This allows the system to settle after
disturbance in transit.
INSULATION
Ensure that there is sufficient space between the freezer and the wall for correct air
circulation and opening of the lid. Locate away from sources of heat such as stoves,
radiators, etc.
Two wall spacers are provided. These should be clipped to the top corners of the rear frame
work.
While the freezer can be used in an out-building or garage, it must not be located where it is
in direct sunlight or where the temperature rises due to effects of the sun. The freezer
should not be positioned where it will be affected by draughts or dampness.
ELECTRICAL CONNECTION
Do not use an extension cord. The refrigerator should be connected to an appliance outlet
with no other appliance on the line, otherwise an overload condition might occur. The
grounding plug on this appliance is compulsory by law. For these reason, the (3-pronged)
grounding plug of this refrigerator must be plugged into a matching grounding outlet which
supplies 120 VOLT 60 Hz single phase. Do not file or cut the grounding plug.
CAUTION
Danger of electrical shock. Remove plug from from the power outlet before cleaning or
servicing. Unplug the refrigerator from the outlet to completely disconnect it from the
electrical system supply.
BEFORE USE
Wash the interior of the freezer using a solution one teaspoonful of bicarbonate of soda to
each pint of warm water and dry very thoroughly with a clean dry cloth. Detergents or soap
should not be used as the leave a trace of odor. Abrasive cleaning powders must not be
used in any interior as they may affect the finish.
INDICATOR LIGHTS AND FAST FREEZING SWITCH
Green Indicator This light only shows that the main is connected to the Freezer and does
not give any indication of the temperature inside the Freezer.
Amber Indicator This light will glow while the Fast Freeze switch is on. The switch overrides
the thermostat and the compressor will operate continuously and lower the cabinet
temperatures still further.
TEMPERATURE CONTROL
The temperature control switch, located at the front of the freezer, should be set to position
3 to obtain the correct temperature for storing already frozen foods. This setting may have
to be varied depending upon the frequency of opening and closing the lid and for room
temperature in excess of 25 degrees C {77 degrees F).