Range of 5-24 vdc from source – B&K TX4430 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Range of 5-24 VDC from source
o H
H o
WHtN SWITCH
CTRLIia
IS SEXTO
ENABLE
CTRL
IN
A-Î4V
ENABLE.
JMHL
THEAMPLIFIER
WILL ONLY
OPERATE WHII-F
o
CTRL
OUT
12VOO
A6-24V SIGNAL
IS APPLIED
TO CTRL IN
D EF EAT
Control enable
button
If the control function is desired, each unit in the system must remain connected at ali
times and the control must be enabled. To enable the control function, the CTRL
ENABLE button must be out for each controllable amplifier in the system. For more
information on the amplifiers output status under various control conditions, refer to the
table below.
* Note: The control voltage is for muting control only. Each amplifier must be connected
to its own source of AC power in order for it to operate.
@ CTRL IN
Button position
Output status
@ CTRL OUT
Signal
OUT
Sound
Signal
Signal
IN
Sound
Signal
No Signal
OUT
Mute
No Signal
No Signal
IN
Sound
Signal
Page 9