Clarion PEQ460 - Manual (Page 7)

TROUBLESHOOTING
Problem
Unit does not work; no lights.
Solution
• Power wires are not connected. Check battery and ground wiring at unit;
check battery connections.
Problem
Sound is distorted.
Solution
• Source unit volume is set too high. Reduce source unit volume.
• EQ controls are set too high. Turn EQ controls to the center position and
listen for distortion again. If problem still occurs, see your authorized Clarion
dealer.
• Speakers may be damaged. Consult your authorized Clarion dealer.
Problem
No sound from unit.
Solution
• Wrong input is selcted. Press Aux Switch so that main inputs are on.
• No Remote-On. Using a volt meter, check for +12V from Remote-On source.
PRODUCT SPECS
7
Adjustable ParametricFrequencies:
Boost/Cut:
S/N Ratio:
Frequency Response:
Maximum Output Voltage:
THD:
Input Sensitivity:
Head Room:
Input Impedance:
Output Impedance:
Stereo Separation:
Operating Voltage:
Size:
SUB 20-60Hz, LOW120-300Hz,
MID 1.0-2.4 Khz, HIGH 7.0-20.0 Khz
18dB
110dB
10Hz -50Khz +/-1dB
7V RMS
0.005
50mV– 3V RMS
20dB
10K Ohms
50K Ohms
82dB/1kHz
11 – 15VNegative Ground
24mm H x 178mm W x 110mm D