Cuisinart DLC-2007NC - Manual (Page 7)

THE MACHINE
INCLUDES:
1. Housing base with a
vertically projecting
shaft and convenient
touchpad control panel.
2. 7-cup work bowl.
3. Cover with extra
large feed tube.
4. Pusher assembly
that slides inside
the feed tube.
5. Dough blade.
6. Sharp metal chop-
ping/mixing blade.
7. Serrated slicing disc.
8. Shredding disc.
9. Detachable stem
for discs (not shown).
10. Plastic spatula
(not shown).
The metal chopping blade
chops raw and cooked
fruits, vegetables, meat,
fish and cheese to the
exact consistency you
want, from coarse to fine,
even to a purée. It chops
nuts, makes nut butters,
mayonnaise and sauces,
and mixes tender, flaky
pastry. The metal chopping
blade also mixes cakes,
frostings, cookies,
quick breads, muffins,
and biscuits.
The slicing disc makes
beautiful whole slices
without torn edges.
It slices whole fruits and
vegetables, cooked meat,
semi-frozen raw meat and
loaves of bread.
The shredding disc
processes most firm and
hard cheeses into long,
attractive shreds. It also
shreds vegetables like
potatoes, carrots and
zucchini, and processes
nuts and chocolate to a
grated texture.
The detachable stem fits
both discs, making disc
storage compact in
limited space.
The pusher assembly
has two parts.
1. A small, removable,
clear pusher that fits into
a small center-located
feed tube. This tube is
for narrow food like
carrots, for adding liquid,
and for continuous
feeding of small food
like garlic.
2. A large pusher that fits
into the Cuisinart ®
Supreme ® feed tube
opening and moves
freely within it.
Upon contact, the large
pusher meets an activating
rod in the center of the
work bowl handle, permit-
ting the motor to start.
ASSEMBLY
INSTRUCTIONS:
Blade Operation
1. Plug in the housing base
and place the work bowl
on top, with the work
bowl handle just to the
left of center. Turn the
work bowl counterclock-
wise to lock it onto the
housing base.
2. CAREFULLY lift and
place the chosen blade
over the work bowl
center shaft. Line up the
markings on the blade
hub with the motor shaft.
Blade should fit snugly and
rest on the bottom of the
work bowl.
3. Add desired ingredients
to work bowl.
4. Place work bowl cover
onto work bowl, with
the handle area just to
the left of center. Turn
counterclockwise to
lock onto work bowl.
5. Align pusher assembly
and activating rod with
the feed tube opening on
the work bowl cover and
slide the activating rod
down to the bottom.
6. You are now ready to
operate the machine.
Disc Operation
1. Plug in the housing base
and place the work bowl
on top, with the work
bowl handle just to the
left of center. Turn the
work bowl counterclock-
wise to lock it onto the
housing base.
2. Choose desired disc
and place underside-up
on tabletop. Pick up
detachable disc stem
and align it with the
raised plastic crescent
on the disc underside.
The raised ‘lock’ indica-
tor on the left corner of
the stem should be to
the left of the mounting
plate on disc.
3. Turn the stem to the
right, so the locking tabs
are covered by the metal
supports and a ‘click’
locks the stem in place.
4. With the stem facing
down, place the assem-
bly over the center hub.
It should fit snugly and
rest on the bottom of the
work bowl.
6
03CU13535 DLC-2007N IB-5053 10/2/03 2:36 PM Page 7