Casablanca Fan Company Casablanca Seacoast' Ceiling Fan C3U72M - Manual (Page 10)

10
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating
wall control/switch.
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating
Screw
6-32 X 1"
(2)
Screw
6-32 X 3 /
8
"
(2)
Wood
Screw
1" (2)
Drywall
Anchor
6-32 (2)
12v Battery
W-73
Control
Holder
Standard Light Switch
Step a. Remove the two screws holding the switch cover plate.
Do not remove the cover plate.
Step b. Orient the control bracket as shown and line up the
two inner mounting holes with those on the switch.
Step C. Install and tighten screws using the provided Phillips
screwdriver.
Inner
Mounting
Holes
Control Bracket
Standard
Toggle
Switch
Switch
Cover
Plate
Outer
Mounting
Holes
Control
Bracket
Rocker
Type
Light
Switch
Switch
Cover
Plate
Wall Installation
Step a. Locate a 2x4 wall stud
in a convenient location.
Step b. Orient the control
bracket as shown over the
2x4 stud.
Step C. Use the 1" wood
screws in either the inner
or outer mounting holes.
Install and tighten screws
using the provided Phillips
screwdriver.
Decor Ovalhead Screw
6-32 X 1"
Anchor
Panhead
Screw
Drywall Anchor
NOTE: Th e wall anchors and 6-32 x 1" screws may
be used in situations where mounting to a stud is not
possible. Use the inner mounting holes. After securing
the anchor, discard the anchor’s pointed screws and use
the 6-32 decor ovalhead screws supplied.
CAUTION! Do not use with wall dimmer.
Wood
Screw 1"
CONTROL BRACKET INSTALLATION
W-73
Tabs
VERSA•TOUCH2™ INSTALLATION
VERSA•TOUCH2™ INSTALLATION HARDWARE (not to scale)
Rocker Light Switch Rocker Light Switch
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step C. Orient the control bracket as shown and line up the
two inner mounting holes with those on the switch.
Step D. Install and tighten screws removed in Step B by
hand only.