Line 6 M9 User Manual

Page 4

eaR

onneCtions

1. Cable Retainer -

Wrap your power supply cable around this once or

twice to prevent an accidental disconnect.

2. Power -

Connect your Line 6 Power Supply here to power the unit.

3. MIDI In/Out -

Please see

www.line6.com/manuals

for the skinny on

MIDI features, which allow you to remote control scene changes, FX

unit memory selection, looper operation, expression pedals, and tap

tempo. Plus dump and receive scene data via MIDI System Exclusive

messages.

4. Expression Pedal 1 + 2 -

Compatible with standard expression pedals,

including the Line6 EX-1. Control FX parameters in real time by

assigning them to either of these expression pedal inputs. The Line6

expression pedal is a passive 10K ohm mono linear taper pot, using a

standard 1/4 inch mono instrument cable.

5. Stereo Input -

When connecting your guitar or other mono source use

the

L(MONO)

input.

6. Stereo Output -

For mono output, use the

L(MONO)

output.

asiC

peRation

Growler

MIX

FILTER

0.84HZ

FREQ

PITCH

1. FX (1,2,3) Units -

You can run up to 3 effects at once. Each FX Unit has

2 memories (

A & B

), which can run any model of any type (Distortion–

yellow, Delay–green, Modulation–blue, Filter–purple & Reverb–

orange.

2. Memory Footswitches -

All FX Units have 2 memories (

A & B

). Only

one memory can be active at a time: its footswitch will be brightly lit,

and colored to show the effect type. Inactive switches are dimly lit. Step

on a footswitch to activate that memory. Step on an active memory

switch to bypass the FX Unit.

3. Display -

Your display will show all the settings for the most recently

selected FX Unit memory (shown in upper left corner of the display).

The display illuminates the color of current effect type (Distortion–

yellow, Delay–green, Modulation–blue, Filter–purple & Reverb–orange).

When a currently displayed FX Unit is turned off the display will show

the first active FX Unit in your signal chain. If no FX Units are on the

display will read “

All FX Bypassed

”. To edit an active FX Unit that