CDA SV430 - Manual (Page 6)

General Settings and Use
Clock
To set the clock when the time and the clock indicator are
flashing (for example, when the oven is first switched on) turn the
selection control knob until the correct time shows on the display,
then touch to confirm the selection. The oven will beep to
confirm the selection and the clock and clock indicator will stop
flashing.
To set the clock once the time has been set (when the clock is not
flashing) touch twice until the clock and the clock indicator
flashes. Turn the selection control knob until the correct time
shows on the display, then touch to confirm the selection. The
oven will beep to confirm the selection and the clock and clock
indicator will stop flashing.
Minute minder
This oven is equipped with a minute minder to count down for a
maximum of 60 minutes. To set the timer, touch so the display
flashes 0:00 and the minute minder indicator flashes. Turn the
selection control knob until the required time shows on the
display. The minute minder will set after three seconds delay and
starting counting down.
The display will show the time remaining and the minute minder
indicator will stay lit. At the end of the countdown, the minute
minder indicator will flash and the oven will beep intermittently
for approximately 80 seconds. To stop the end of timer alerts
before that time, touch .
To check on the progress of the minute minder during a
programme, touch until the minute minder indicator flashes
and the time remaining will show on the display.
To cancel the minute minder touch until the minute minder
indicator flashes and then turn the selection control knob until the
display shows 0:00.
5
Fig.5
Fig. 6