Schwinn Airdyne AD6 - Manual (Page 25)

25
TROUBLESHOOTING
Condition/Problem Things to Check Solution
Console will not power up/
turn on/start
Batteries Make sure batteries are installed correctly. If batteries are
correctly installed, replace with a set of new batteries.
Check data cable integrity All wires in cable should be intact. If any are visibly crimped or
cut, replace cable.
Check data cable
connections/orientation
Make sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Check console display for
damage
Check for visual sign that console display is cracked or
otherwise damaged. Replace Console if damaged.
If the above steps do not resolve the problem, contact
Customer Care for further assistance.
Speed displayed is not
accurate
Display set to wrong unit
of measure. (English/
Metric)
Change display units (consult “Console Service Mode”)
Speed displayed is always
“0”/stuck in Pause mode
Data cable Make sure the data cable is connected to the back of the
Console and the main frame assembly.
Speed Sensor (under
Shrouds)
Make sure the Speed Sensor Magnet and the Speed Sensor
are in place.
No speed/RPM reading Check data cable integrity All wires in cable should be intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Check Speed Sensor
Magnet position (requires
shroud removal)
Magnet should be in place on pulley.
Check Speed Sensor As-
sembly (requires shroud
removal)
Speed Sensor Assembly should be aligned with magnet and
connected to data cable. Realign sensor if necessary. Replace
if there is any damage to the sensor or the connecting wire.
Console displays “Lbatt”
error code
Batteries Replace batteries
Unit operates but Tele-
metric Heart Rate not
displayed
Chest Strap (optional) Strap should be “POLAR ® ” compatible and uncoded. Make
sure strap is directly against skin and contact area is wet.
Interference Try moving unit away from sources of interference (TV, Micro-
wave, etc).
Replace Chest Strap If interference is eliminated and HR does not function, replace
strap.
Replace Console If HR still does not function, replace Console.
Console shuts off (enters
sleep mode) while in use
Check data cable integrity All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into
place.
Check Speed Sensor
Magnet position (requires
shroud removal)
Speed Sensor Magnet should be in place on pulley.
Check Speed Sensor As-
sembly
Contact Customer Care for further assistance.