MTD 112-930 User Manual
Rotary mower, Mtd products inc, Safe operation practices - walk behind mowers
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10*
ROTARY MOWER
I M r O R T A
Model No.
112-930
SAFE OPERATION PRACTICES - WALK BEHIND MOWERS
TRAINING
1.
Read the Operating and Service Instruction Manual
carefully. Be thoroughly familiar with the controls and
proper use of the equipment.
2. Never allow children to operate a power mower.
3.
Keep the area of operation clear of all persons,
particularly small children, and pets.
PREPARATION
1. Thoroughly inspect the area where the equipment is to
be used and remove all stones, sticks, wire, bones and
other foreign objects.
2.
Do not operate equipment when barefoot or wearing
open sandals. Always wear substantial footwear.
3.
Check fuel before starting engine. Do not fill gasoline
tank indoors, when engine is running, or while engine
is still hot. Wipe off any spilled gasoline before starting
engine.
4.
Disengage self-propelled mechanism or drive clutch on
units so equipped before starting engine (motor).
5.
Never attempt to make a wheel height adjustment while
engine (motor) is running.
6. Mow only in daylight or in good artificial light.
7. Never operate equipment in wet grass.. Always be sure
of your footing; keep a firm hold on the handle and
walk; never run.
OPERATION
1.
Do not change engine governor settings or overspeed
engine.
2.
Do not put hands or feet near or under rotating parts.
Keep clear of discharge opening at all times.
3. Stop blade(s) when crossing gravel drive, walks or roads.
4.
After striking a foreign object, stop the engine (motor),
remove wire from spark plug, thoroughly inspect the
mower for any damage, and repair the damage before
restarting and operating the mower.
5.
If the equipment should start to vibrate abnormally,
stop the engine (motor) and check immediately for the
cause. Vibration is generally a warning of trouble.
6. Stop engine (motor) whenever you leave the equipment,
before cleaning mower housing, and when making any
repairs or inspections.
7.
When cleaning, repairing or inspecting, make certain
blade and all moving parts have stopped. Disconnect
spark plug wire and keep wire away from plug to prevent
accidental starting.
8. Do not run engine (motor) indoors.
9. Shut engine (motor! off and wait until blade comes to a
complete stop before removing grass catcher and/or
unclogging chute.
10.
Mow across the face of slopes, never up-and-down.
Exercise extreme caution when changing direction on
slopes. Do not mow excessively steep slopes.
11.
Always disconnect electric mowers (line operated)
before cleaning, repairing, or adjusting.
12.
Never operate mower without proper guards, plates or
other safety protective devices in place.
13. Keep washout ports and other mower housing service
openings closed when mowing.
MAINTENANCE AND STORAGE
1.
Check blade and engine mounting bolts at frequent
intervals for proper tightness.
2. Keep all nuts, bolts, and screws tight to be sure equip
ment is in safe working condition.
3. Never store equipment with gasoline in the tank inside
of a building where fumes may reach an open flame or
spark. Allow engine to cool before storing in any
enclosure.
4. To reduce fire hazai’d keep engine free of grass, leaves or
excessive grease.
5. Check grass catcher bags frequently for wear or deterio
ration. Replace with new bags for safety protection.
MTD PRODUCTS INC
5389 WEST 130th STREET
P. 0. BOX 2741 CLEVELAND OHIO 44111
FORM NO. 770-3941