Assembly, Tools required for assembly, Operator’s position (see fig. 1) – Poulan 161673 User Manual
Page 5: Contents of hardware pack, Elon
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To
ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) Utility knife
(1) Pair of pliers
(1) Screwdriver
(2) 1/2" wrenches
OPERATOR’S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating position (standing
behind tiller handles).
LEFT
FRONT
ElOn
RIGHT
OPERATOR'S
POSITION
FIG. 1
CONTENTS OF HARDWARE PACK
(2) Hex Bolts 5/16-18
X
3/4
(2) Hex Bolts 5/16-18 x 1
(1) Cotter Pin
o
(1) Clevis Pin
(6) Hex Nuts 5/16-18
(
2
)
Hex Bolts 5/16-18 x 1-1/4
(6) Lock Washers 5/16