Assembly instructions, Ac warning – MTD 240-685-000 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LOCK
NUT (E)
EXTENSION
SPRING (D)
\
CLUTCH
ROD (Q)
7. Slide the extension spring (D) onto clutch rod (Q)
as shown in figure 10. Thread lock nut (E) onto
clutch rod approximately 2-1/2 inches.
FIGURE 10
CLUTCH
BRACKET
ASSEMBLY
8.
Hook top (hooked end) of clutch rod into clutch
grip. Hook spring into clutch bracket assembly.
See figure 11. Spring should not have any slack.
Adjust nut so that when the clutch grip is all the
way up, there is no slack in the spring.
9.
Thread hex jam nut (M) onto clutch rod, and
lock it against the lock nut (E).
FIGURE 11
HAND
KNOB
ASSEMBLY INSTRUCTIONS
To Convert from a Vacuum to a Leaf Blower.
Ac
WARNING {
FIGURE 12
Engine must be stopped (off) and
spark plug wire disconnected.
1. Remove the bag.
2. Remove the air duct assembly by removing two
hand knobs and belleville washers.
3.
Remove the nozzle by removing one hand knob
and belleville washer.
-4. Remove the hand knob and belleville washer
holding the housing to engine brace. See figure 12.