Assembly, Carton contents, Hardware for assembly – MTD 190-459A-100 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
CARTON CONTENTS
1.
Sweeper Assembly
2.
Brace Rods (2)
3.
Rope
4.
Hopper Assembly
HARDWARE FOR ASSEMBLY
Hardware Is preassembled to sweeper and hopper.
TOOLS REQUIRED
(1) 1/2" Wrench
1.
Remove the nuts, lock washers and bowed washers
from the two curved head bolts, leaving the bolts in
the tube at the front of the sweeper housing. See
figure 1.
2.
Loosen the knob fastening the height adjustment
handle to the height adjustment strap. See figure 1.
3.
Place the base of the height adjustment handle onto
the two curved head bolts and secure it with the
bowed washers, lock washers and hex nuts that you
removed. See figure 1.
4.
Attach the ends of the lower hopper tubes to the
Inside of the side hopper tubes using the two 3/8" x
1/2" clevis pins and 3/32" hair cotter pins which came
preassembled to the tubes. See figure 2.