Assembly, Instructions, Assembly instructions – MTD 110-072A User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Lower
Handle
ASSEMBLY
INSTRUCTIONS
Inner
Hole
Outer
Hole
Weld Pin
FIGURE 1.
Lower
Handle'
Hex Lock-
Nut
A
Upper
Handle
FIGURE 2.
/'
\
^ Carriage Bolt
1.
Extend throttle control which is attached to
the engine at the rear of the mower and place
on the floor. Be careful not to bend or kink
control wire.
2.
Fasten lower handle in position over weld
pins
in
handle
mount
brackets
on
deck.
Secure with hairpin cotters in inner hole on
weld pin. See figure 1.
NOTE
There are two (2) holes in the handle
mount
brackets.
Place
the
lower
handle
against
the
brackets
and
secure with hairpin cotter in the in
ner hole, inner hole is for operation.
Outer hole is for storage.
NOTE
It may be necessary to pull open the
ends of the lower handle. This will
insure a tight fit when assembled in
to handle mount brackets.
3. Assemble upper handle to lower handle.
—Secure with two carriage bolts and hex lock
nuts as shown in figure 2.
NOTE
There are two height positions for
the handle. See adjustment section.
I
Place the throttle control in position on
right
side of upper handle. Secure with hex bolt and
lock nut. See figure 3.
NOTE
Reference to right and left hand
sides of the unit is observed from
the operating position.
FIGURE 3.