MTD 241665 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SPACER (L)
AXLE
SHAFT
FLAT
WASHER (M!
Slide spacers (L) onto the axle shafts. Place one
flat washer (M) on each shaft next to the spacers.
See figure 4.
FIGURE 4
PUSH
CAP (N)
Place rear wheels in position on the shafts, then
another flat washer (M). Secure with black push
cap (N) by placing the push cap in position and
tapping on with hamrner or rubber mallet. See
figure 5.
FIGURES
UPPER HANDLE
LOWER
HANDLE
Place the upper handle (C) in position over lower
handle. Fasten with four hex bolts (O) and hex
lock nuts (P) provided. See figure 6. Two
7/16" wrenches are required.
FIGURE 6
This manual is related to the following products: