Assembly instructions, Assennbly instructions – MTD 243-689A User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Lift up on the housing and rotate it 105® clock
wise. Chute opening should be to the right hand
side when viewed from the front of unit. See
figure 13.
Place the impeller guard (S) i.no flanges on front
of housing. Line up hole in screen with hole on
housing. Secure with one hand knob, belleville
washer and heavy fiat washer (H). See figure 13,
FIGURE 13
DIRECTtONAL
DISCHARGE
ASSEMBLY (R)
7. Place the directional dishcarge assembly (R) over
chute opening. Secure with two hand knobs and
belleville washers. See figure 14.
FIGURE 14
ASSEMBLY INSTRUCTIONS
for Tow Bar Kit.
1. Remove the self tapping screws on each side of
frame. Refer to drawing on page 12, reference
number 42.
2.
Place tow bar half in position on frame. Place
one shoulder spacer (U) between frame and
tow bar. Next, place shoulder spacer (U) and hex
bolt (V) through tow bar and frame. Secure with
lock washer (2) and hex nut (AA). See figure 15.
3.
Secure the two tow bar ends together with hex
bolt (W), lock washer (X) and hex nut (Y). See
figure 15.