Poulan Chainsaw - Manual (Page 4)

ASSEMBLY - PARTS AND TOOLS
Check the box for each item shown here. If something is
missing, please call place of purchase.
. ■ - . i s - i ' CHAIN SAW POWER HEAD
rCONTRQL TIR m BAR
\
SCP
BAR ADJUSTING TOO l ]
YOU WILL NEED:
AH of the items shown here plus a large
screwdriver, work gloves, uncluttered work
area, approved mixing container for fuel.
For CounterVibe Model, a small adjustable
wrench.
YOU WILL;
• Attach the hand guard.
• Mount the bar and chain.
• Adjust the chain.
FOR MIXING FUEL AND
ADDING CHAIN OIL:
You will need the proper fuel mixture, (see
the fueling section of this manual, page 6),
and, bar and chain lube or clean SAE 30 oil.
ATTACHING THE
HAND GUARD
The hand guard helps prevent the hand from coming in contact with the cutting chain
should your hand slip off the handlebar. It does not eliminate the possibility of injury
from kickback or loss of control of the saw. Please lift and carry the chain saw by the
handlebar or the control handle, NOT by the hand guard, so it will not come loose.
Retighten, if it ever does come loose. DO NOT USE THE SAW WITHOUT THE HAND
GUARD IN PLACE.
COUNTERVIBE MODELS
1. Align 2 parts of hand guard around
handlebar so knob of guard fits the
hole in the handlebar.
2. Insert the 3 mounting screws into
the 3 holes on hand guard.
3.Turn each screw a little at a time
clockwise to tighten until the two
halves meet and are tight. Move
from 1 screw to the next, a couple
of turns to secure guard evenly.
Remove 6-sided hex bolt from
CounterVibe Bracket. Place hand
guard base over the bracket. Tight­
en the bolt.