Preparing your mower for use, Set-up – MTD 10710-0 User Manual

Page 3

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

PREPARING YOUR MOWER FOR USE

UPPER HANDLE

HANDLE COVER

LOWER HANDLE

SET-UP

To assemble the handle to the chassis — place the lower handle through the opening in the left hand end plate

and slip it over the 1/2 in. dia. trunnion. While holding the stand-up handle latch open — press the right hand

side of the lower handle toward the center of the mower until it will fit into the opening in the end plate —

place handle through the opening and slip it over the 1/2 dia. trunnion.

With the lower handle section in operating position the upper handle can now be loose assembled to the lower

section with the nuts and bolts provided. Fit handle cover in place as shown and tighten bolts securely.