Poulan PLN3516F - Manual (Page 15)

When bucking on a slope, always stand on
the uphill side.
1. Log supported along entire length; Cut
from top (overbuck), being careful to
avoid cutting into the ground (Figure
5-3A).
2. Log supported on 1 end: First, cut from
bottom (underbuck) 1/3 diameter of log
to avoid splintering. Second, cut from
above (overbuck) to meet first cut and
avoid pinching (Figure 5-3B).
3. Log supported on both ends: First,
overbuck 1/3 diameter of log to avoid
splintering. Second, underbuck to meet
first cut and avoid pinching (Figure
5-3C).
NOTE: The best way to hold a log while
bucking is to use a sawhorse. When this is
not possible, the log should be raised and
supported by the limb stumps or by using
supporting logs. Be sure the log being cut
is securely supported.
5-3C
5^4. BUCKING USING A SAWHORSE
For personal safety and ease of cutting,
the correct position for vertical bucking is
essential (Figure 5-4A).
VERTICAL CUTTING:
A. Hold the saw firmly with both hands
and keep the saw to the right of your
body while cutting.
B. Keep the left arm as straight as
possible.
C. Keep weight on both feet.
CAUTION
While the saw is cutting, be sure the chain
and bar are being properly lubricated,
6 - BAR/CHAIN M AINTENANCE
6-1. GUIDE BAR MAINTENANCE
WARNING
Ensure that the power cord is disconnect­
ed before performing any maintenance on
your saw.
Proper maintenance of the guide bar, as
explained in this section, is essential to
keep your saw in good working order.
SPROCKET TIP LUBRICATION:
(For units supplied with sprocket tip guide
bars only.)
CAUTION ©
Failure to lubricate the guide bar sprocket
tip as explained below will result in poor
performance and seizure, voiding
the manufacturer’s warranty.
Lubrication of the sprocket tip is recomme­
nded after each saw use. Always
thoroughly clean the guide bar sprocket tip
before lubrication.
Tool for lubrication: Poulan Lube Gun
(disposable)
This grease gun is designed to fit the small
lubrication point on the guide bar.
The disposable Lube Gun is packed with
grease. For information on where to
purchase a lube gun, contact the Poulan
Product Service Department toll-free
number listed on the back cover of this
manual.
15