Cerwin-Vega POWERED DESKTOP XD3 - Manual (Page 12)

11
Please note that product and warranty registration gives Cerwin-Vega!
permission to send you information about new and existing products and
promotions. If you do not wish to be contacted regarding new products and
promotions, please opt out during the product/warranty registration process.
You will continue to receive important product updates concerning your
purchased Cerwin-Vega! products.
Troubleshooting Tips
No Power
The XD3 features a power indicator around the volume control knob on the left
speaker. This ‘ring’ will be lit when the XD3 is powered ‘on’.
Be sure the XD3 is being used with the correct power source. Do NOT use the
XD3 intended for 100-120V on a power source that is 220-240V. Do NOT use
the XD3 intended for 220-240V on a power source that is 100-120V. The XD3 is
marked appropriately on the back of the left speaker.
Make sure the power cord is securely seated and plugged all the way into the
‘AC IN’ socket of the XD3 speaker. Be sure the power cord is plugged all the
way into the AC outlet.
Check that the AC outlet is live (such as using a lamp or qualified tester from
the same outlet). In some cases, the AC outlet may be controlled by a light
switch or the power strip has a switch in the incorrect ‘off’ position.
Verify that the power switch on the rear of the XD3 speaker is in the ‘on’
position. The ‘on’ position is where the ‘|’ symbol is pressed down.
No Sound
Verify that the XD3 is powered ‘on’. See the above section.
Make sure the audio cable is plugged into both the source output (computer or
portable media player) and the XD3 audio input (either the two RCA jacks
located on the rear or the ⅛” ‘AUX IN’ jack located on the front).