Wff81-c, Model, Optional fan kit – Louisville Tin and Stove W506 User Manual
Page 13: Installation instructions
Page 13
MODEL
WFF81-C
OPTIONAL FAN KIT
INSTALLATION INSTRUCTIONS
NOTE: This fan kit is to be installed after installation of wall furnace and with the wall furnace front panel in
place.
STEP 1.
This appliance, when installed, must be electrically grounded in accordance with local codes, or in
the absence of local codes, with the latest edition of the National Electric Code, ANSI/NFPA
No. 70. In Canada, see the current Canadian Electrical Code CSA C22.1.
STEP 2.
Set fan kit on top of the wall furnace front panel. Using the back top edge of the fan kit cabinet
as a guide, mark a horizontal line across the wall. Mark a small vertical line which aligns with the
slot located toward the rear of the fan kit casing.
STEP 3.
Using the four one inch screws provided, secure the wall mounting bracket to wall 1/8” below the
horizontal line. Fan attachment bracket must be up and threaded nut sert aligned with the small
vertical line. Note: Anchors (not provided) may be required.
STEP 4.
Remove junction box and connect 115v power supply in accordance with the wiring diagram.
Replace junction box.
STEP 5.
Set fan kit on top of wall furnace front panel. Slot should align with the nut sert. Secure fan kit
to wall mounting bracket with thumb screw provided.
Wiring
Diagram
Junction
Box
Wall Furnace
Front Panel
Fan
Kit
One Inch
Screw (4)
Wall Mounting
Bracket
Threaded Nut
Sert
Thumb
Screw
Fan Attachment
Bracket
Slot