Sears 200.71488 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

To operate a 12V DC device:
1. Open the protective cover of the DC
power outlet on the front panel of the
Portable Power 1150.
2.
Plug the 12V DC device into the DC
power outlet, and turn on the 12V DC
device (if required).
3.
If both 12V DC devices combined
draw more than 30 amps, the fuse will
blow. To replace, contact a qualified
service technician.
4. Charge the Portable Power 1150 as
soon as possible after each use.
Because the DC power outlet is in
ternally wired directly to the internal
battery, extended operation of a 12V
DC device may result in excessive
battery drain.
12V DC ELECTRICAL DEVICE EXAMPLE RUN-TIME CHART
Appliance Type
Fluorescent Lights, Cellular Phones
Radios, Depth Finders, Fans
Camcorders, DVD Players, Spotlights
Electrical Tools, Bilge Pumps
Electric Coolers
Air Compressors, Car Vacuums
Estimated Wattage Estimated Time*
4 Watts
9 Watts
15 Watts
24 Watts
48 Watts
80 Watts
50 Hours
25 Hours
13 Hours
7.3 Hours
4.5 Hours
2 Hours
*NOTE: Estimated run-times. Actual time may vary. Times are based on the internal
battery being fully charged.
AIR COMPRESSOR, INFLATOR AND DEFLATOR
USING THE AIR COMPRESSOR
CAUTION: Read instructions of the
product being inflated before using the
compressor. Avoid over inflation, do not
exceed the manufacturer’s recommended
pressures. Do not leave the air compres
sor unattended during use.
1.
Remove the air compressor hose
from the storage compartment in the
back of the Portable Power 1150.
2. Attach the air compressor hose to the
product or accessory to be inflated by
flipping down the lever.
3. Push the air compressor switch to the
ON position and inflate product.
4.
When the product is inflated to the
proper air pressure, push the com
pressor switch to the OFF position
and remove the hose.
5. Do not run for more than 10 minutes
maximum at a time. If you do, allow
the 1150 to cool down for 10 minutes
before using again.
NOTE: If the compressor overheats, the
built-in thermal protection will turn the
unit off. Wait a few minutes and it will
automatically restart.
NOTE: The air compressor is rated for
150 PSI.
ESTIMATED TIME FOR INFLATING
6 to 24 minutes
Vehicle Tires
13” to 16”
Bike Tire
Sports Balls
1 to 3 minutes
30 seconds
Use the air compressor gauge to ensure
the proper pressure has been reached.
Do not over inflate.
USING THE INFLATOR
CAUTION: Read instructions of the prod
uct being inflated before using the inflator.
Avoid over inflation, do not exceed the
manufacturer’s recommended pressures.
Do not leave the inflator unattended dur
ing use.