Sears 680.88973 - Manual (Page 5)

1. Raise dispenser top "A" (FiG. 10). Position
dispenser "F“ in base "B".
2. Press top dispenser firmly against the
handle -tube "G" Valve stem "C" must be
above valve lifter -D“ (FIG. 11).
3. Slide dispenser top "A" down so that it
engagesthe dispenser and holds it securely
in position.
To dispense the liquid, pull trigger “E"
momentarily and intermittently. Liquid will flow
as long as the trigger is raised
Note: If the dispenser fails to discharge liquid
when the trigger is raised all the way, tilt the
dispenser away from the handle tube. Take a
pair of long-nosed pliers and grasp the valve
lifter "D".
Bend thé two projections (tabs) at the same
time upward until a dime fits snugly between
the bottom of the valve stem "C" and the top of
the valve lifter "D" (FIG. 11).
If liquid continues to flow when the trigger is
released, grasp the valve lifter close to the
handle and bend the two projections downward
until a dime fits snugly between the bottom of
the valve stem and the top of the valve lifter.
DISPENSING SYSTEM MUST BETHOROUGHLY
CLEANED IMMEDIATELY AFTER EACH USE, DO
NOT STORE LIQUID IN DISPENSER.
Remove dispenser from unit and empty. Rinse
thoroughly with warm water. The dispensing
system must be flushed immediately after use.
Partially fill dispenser with warm water, mount
on unit and then dispense all the water into a
receptacle placed under the unit.
BRUSHES__________ ___________________________
ELECTRIC CORD PLUG SHOULD ALWAYS BE
DISCONNECTED FROM THE ELECTRICAL OUT­
LET BEFORE ATTACHING, REMOVING OR
CHANGING BRUSHES.
1. Lay the polisher flat exposing the underside
of the unit (FIG. 12). Using a rotating motion
push the brush on the spindle as far as it will
go.
2. After each use remove brushes with a slight
pull.
3. Wash in warm soapy water after each use.
Shake out excess water. Stand bristles on
paper towel to dry.
DO NOT USE HOT WATER.
DO NOT FORCE DRYING BY USING AN OVEN
OR RADIATOR HEAT.
4. Remove brushes from the machine when not
in use to extend the life of the brush.
PADS__________________________________________
THE ELECTRIC CORD PLUG SHOULD ALWAYS
BE DISCONNECTED FROM THE ELECTRICAL
OUTLET BEFORE ATTACHING, REMOVING OR
CHANGING PADS.
1. To attach pads on Shampooer/ Polisher: Push
the ends of the adapters (provided in the
hardware package) through the holes in the
pads, then snap adapters on to the Scrubbing
Brushes.
DO NOT attach to Shampoo
Brushes.
2 may be cleaned if desired in warm soapy
water. Rinse thoroughly. Stretch out to shape
and allow to dry.